الاثنين، 13 يوليو 2020

Solar Energy

Solar Energy 
The energy from the sun can be exploited directly in the form of heat or first converted 
into electrical energy and then utilized. Accordingly the solar energy is classified into 
solar thermal and solar photovoltaics (PV). 

Solar thermal has numerous applications like water heating, drying vegetables and 
agricultural products, cooking etc. In Nepal the solar water heaters are being extensively 
used in urban areas. The applications of solar dryers and cookers have found moderate 
use simply because of the low level of dissemination of these technologies. 
The solar PV, on the other hand, is extensively used not only in the developing countries 
but also in highly developed countries. The application of solar PV is virtually unlimited. 
Countries like Germany, Japan and United States of America have initiated highly 
subsidized rooftop programs for solar PV. The level of subsidy is up to 65% of the total 
system cost. In Nepal solar PV is extensively used for communications, home lighting, 
drinking water pumping etc. The installed capacity of Solar PV in Nepal now exceeds 3.4 
MWp mark and over 93,000 households are electrified using this technology. 
Considering the positive impact that solar PV can bring to the rural population of the 
developing countries like Nepal, the Government of Kingdom of Denmark has supported 
Energy Sector Assistance Program (ESAP) to promote alternative energy sources, 
including PV. ESAP target was to subsidize installation of 25,000 Solar Home Systems 
within a time span of 5 years. Similarly, a sizeable project with assistance from European 
Union (EU) is being implemented to promote institutional Solar PV in Nepal. 
The solar PV can be considered the only form of electricity that can be generated any 
time and anywhere provided sunshine is available. The earth receives more energy from 
the sun in just one hour than the world uses in a whole year. The annual total amount of 
solar energy incident on the surface of the earth is estimated to be about 795 x 1012 MWh, 
which is 8300 times greater than the global energy demand in 1991. The Environmental 
savings from the Photovoltaic modules are highlighted in table 3.1 below: 
Table 3.1 Environmental Savings from Photovoltaic Modules 
Description Savings of one 50Wp module * 
Electricity saved per year 90 kWh 
Electricity saved per life of PV module 2700 kWh 
Barrels of oil saved over lifetime of PV module 4.8 barrels 
Pounds of coal saved over lifetime of PV module 2700 lbs 
Carbon Di-oxide kept out of the air over life of PV 4000 lbs 
Sulfur Di-oxide kept out of air over life of PV 23.3 lbs 
* Based on: 
Coal required to produce 1 kWh = 1 lb 
Carbon Di-oxide emission = 1.5 lb/kWh

Photovoltaic (PV) Technology 
Photovoltaic (PV) Technology is a process of generating electrical energy from the 
energy of solar radiation. The principle of conversion of solar energy into electrical 
energy is based on the effect called photovoltaic effect. The smallest part of the device 
that converts solar energy into electrical energy is called solar cell. Solar cells are in fact 
large area semiconductor diodes, which are made by combining silicon material with 
different impurities. The sand, a base material for semiconductor, is the most abundantly 
available raw material in the world. The ordinary sand (SiO2) is the raw form of silicone. 
The solar energy can be considered as a bunch of light particles called photons. At 
incidence of photon stream onto solar cell the electrons are released and become free. The 
newly freed electrons with higher energy level become source of electrical energy. Once 
these electrons pass through the load, they release the additional energy gained during 
collision and fall into their original atomic position ready for next cycle of electricity 
generation. This process of releasing free electrons (generation) and then falling into 
original atomic position (recombination) is a continuous process as long as there is the 
stream of photons (solar energy) falling onto the solar cell surface. 

History of Development of PV Technology 
The birth of PV technology dates back to 1839 AD when Edmund Becquerel, the French 
experimental physicist, discovered the photovoltaic effect while experimenting with an 
electrolytic cell made up of two metal electrodes placed in an electricity conducting 
solution—generation increased when exposed to light. 
In 1876 William Adams and R. Day discovered that the junction of selenium and 
platinum also exhibit photovoltaic effect. This discovery led the foundation for the first 
selenium solar cell construction in 1877. 
The photovoltaic effect remained theoretically unexplained until the great scientist Albert 
Einstein described this phenomenon in 1904 along with a paper on his theory of 
relativity. For his theoretical explanation of photo-electric effect, Albert Einstein was 
awarded a Nobel Prize in 1921. 
Another breakthrough in development of PV technology was the discovery of the method 
for monocrystalline silicon production by Polish scientist Czohralski in 1918. This 
discovery enabled monocrystalline silicon solar cells production. The first silicon 
monocrystalline solar cell was constructed only in 1941. 
In May 1954 The Bell Laboratories of USA (Researchers D. Chapin, C. Fuller and G. 
Pearson) published the results of discovery of 4.5% efficient silicon solar cells. 
First commercial photovoltaic product with 2% efficiency was introduced in 1955 by 
Hoffman Electronics-Semiconductor Division. The cost of a 14 milli Watt peak power

solar cell was US$ 25 (or US$ 1,785 per Watt). The efficiency of commercially available 
solar cell increased to 9% in 1958. 
The first PV powered artificial satellite of the earth, Vanguard I, with 0.1 W of solar cell 
occupying an area of approximately 100 cm2
 and powering a 5 mW back-up transmitter 
was launched in 17 March 1958. Three more PV powered satellites were launched in the 
same year. The first PV powered telephone repeater also was built in Americus, Georgia, 
USA in the same year. 
Sharp Corporation was the first company to develop the first usable PV module (group of 
solar cells put together in a single module) in 1963. 
By 1974 the cost of PV power came down to US$ 30 per watt from US$1785 per watt in 
1955. With the dramatic reduction in the cost, the PV power once affordable only in 
space vehicle became an alternative source of electrical energy for terrestrial applications. 
The fig. 3.1 below illustrates the decrease in price (US$ per peak watt) of solar PV with 
time.


ليست هناك تعليقات:

اضافة تعليق

جميع الحقوق محفوظة © 2013 Scientific community
تصميم : يعقوب رضا